Unimog Club UK

General Topics Forums => General Banter! => Topic started by: 411mog on April 16, 2013, 12:21:05 pm

Title: I need hydraulic pipes to copy.
Post by: 411mog on April 16, 2013, 12:21:05 pm

Does any one here in the unimog community have a 411 short wheel base unimog with std metal hydraulic lines front to back that are prepared to remove them so that I can get them copied.
I have finally found a company that can supply the braise on banjo fittings similar to the ones that were used on the front end of the unimog hydraulic lines and need to find a pair of hydraulic pipes to use as a template to create the correct bends to fit around the hydraulic control block.

This is their info page on pipe manipulation and braising
http://www.stauff.co.uk/services/tube-manipulation.aspx

They have 2 branches in the UK.
Do you live near enough to these guys to get them to copy your pipes?
Let me know if you can help.
Tim.