Unable to load photo




« previous next »
Pages: [1]   Go Down

Author Topic: SBU cab tilt mech  (Read 661 times)

Offline cir287

  • Mog Wannabe
  • *
  • Posts: 11
  • Gender: Male
    • View Profile
SBU cab tilt mech
« on: May 21, 2020, 12:39:11 pm »
Attached is a drawing of a mechanism I built for tipping an SBU cab. The drawing isint completely dimensioned but feel free to ask if unsure.
I've built and tested it, it works very well although I'd use an air tool to wind it, its tedious.
No bending or flexing but I'd still use a chock and check strap when in raised position and needless to say dont be under it when raising / lowering.
I built it for pennies, 2no 1m long M30 threaded bars 6no M30 nuts & washers (not sure of cost), 2no thrust bearings (~€5ea) and some scraps I had lying around.

Ciaran
Logged

Share on Facebook Share on Twitter

Like Like x 1 Useful Useful x 1 View List

Offline Unimob

  • Mog Wannabe
  • *
  • Posts: 5
  • Gender: Male
    • View Profile
  • Location: Australia, North Coast, NSW
  • My Vehicles: Unimog U1700l ex ADF
  • Real name: Frank
Re: SBU cab tilt mech
« Reply #1 on: August 08, 2020, 09:56:22 pm »
Very good idea here. Works off the same principle as a vice only on a larger scale. I'm going to give this a go.
Thanks Claran.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
2 Replies
1598 Views 		Last post March 07, 2020, 03:02:52 pm
by Malc
2 Replies
9194 Views 		Last post March 09, 2020, 05:23:56 pm
by Villager